Standing water, particularly the warm water found in a stock tank pool at the end of a hot day, attracts mosquitoes and the bacteria that cause algae. Attach the filter pump tubes to the hardware and then run the pump to fill the pool with water.Ī post shared by Colleen Sherman on at 2:35pm PDTĤ. Installation usually requires drilling a few holes in the tank and feeding the pump hardware into it. To make it easier to fill the pool and filter out human contaminants and bacteria, buy and assemble a filter pump combo (e.g., Intex Filter Pump, available on Amazon). Also consider situating the stock tank pool in the shade of a tree or on a covered patio to maintain pleasant water temperature. In general, the heavier metal tanks require a solid foundation such as concrete, and shouldn’t be set up on wooden decks with weak spots (e.g., rotted wood), but lighter plastic tanks may be set up on either soft or hard surfaces.
#POOL SUPPLY NEAR ME FREE#
The ground must also be level and free of rocks.
You’ll need to ensure that the location can support the weight of the tank, water, and the number of people who’ll be taking a dip. Setup requires careful site selection and a few accessories.Īlthough setting up a stock tank pool is DIY-friendly, it’s not as simple as plopping the tank down anywhere and filling it up. Generally speaking, stock tanks used as pools should have a length or diameter of at least 5 feet and a capacity of at least 80 gallons, equating to the size and capacity of an average bathtub. Tanks can range from 2 to 10 feet in length and width for square or rectangular tanks, and 2 to 10 feet in diameter for round tanks, which can hold between 25 to 800 gallons of water.
Generally, metal tanks cost 35 percent more than plastic ones, and the larger the size and capacity, the more expensive. While an in-ground swimming pool can cost $20,000 to $65,000, and an above-ground pool can set you back $3,500 to $15,000, a stock tank can be had for between $200 to $450. Stock tank pool costs start at $200 and vary depending on the material, size, and capacity. A bit trendier overall, galvanized steel tanks like this 8-foot round tub from CountryLine look chic in a metal finish or can be dressed up with paint.Ģ. These tanks are also less likely to break and don’t need an external frame to stand upright, and the slick metal surfaces can easily be wiped down to remove algae.
#POOL SUPPLY NEAR ME CRACK#
But they’re more likely to crack or break from a heavy impact, and their coarser surface usually demands a good deal of scrubbing to remove dirt and algae that form in the tank over time.
Stock tanks are manufactured out of plastic (usually polyethylene) and metal (usually galvanized steel). You can choose a plastic or a metal stock tank pool. See the most important considerations below before you DIY a stock tank pool! 1. You’ll also need to learn maintenance practices that ensure water in a stock tank pool is safe for swimming-free of debris, human contaminants, and waterborne bacteria that can cause rashes or infections.
A stock tank is widely available at tractor supply stores and well-suited for the farmhouse-rustic design trend, but there are several shopping and setup factors to consider before purchase. You may have seen this farmhouse trend: Stock tank pools repurpose the large containers that traditionally provide water to livestock as affordable alternatives to above-ground swimming pools.
0 kommentar(er)
